Created page with "<blockquote>Excessive cable tensile loading increases the optical loss and may cause increased residual strain in the fibre if the cable cannot relax. To avoid this, the maximum tensile strength determined by the cable construction, especially the design of the '''strength member''', should not be exceeded. Note 1 – Where a cable is subjected to permanent loading during its operational life, the fibre should preferably not experience additional strain. Note 2 – Aer..."
 
No edit summary
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
</blockquote><big>metalen treksterktegeleider = metallic tensile strength member</big>
----
<blockquote>Excessive cable tensile loading increases the optical loss and may cause increased residual strain in the fibre if the cable cannot relax. To avoid this, the maximum tensile strength determined by the cable construction, especially the design of the '''strength member''', should not be exceeded.
<blockquote>Excessive cable tensile loading increases the optical loss and may cause increased residual strain in the fibre if the cable cannot relax. To avoid this, the maximum tensile strength determined by the cable construction, especially the design of the '''strength member''', should not be exceeded.


Line 5: Line 9:
Note 2 – Aerial cable may be attached to a suspension wire. In this case, the '''strength member''' of the cable need only be designed to support the load during manufacture and installation.
Note 2 – Aerial cable may be attached to a suspension wire. In this case, the '''strength member''' of the cable need only be designed to support the load during manufacture and installation.


(‘CONSTRUCTION, INSTALLATION AND PROTECTION OF CABLES AND OTHER ELEMENTS OF OUTSIDE PLANTS’, INTERNATIONAL TELECOMMUNICATION UNION)</blockquote><big>metalen treksterktegeleider = metallic tensile strength member</big>
(‘CONSTRUCTION, INSTALLATION AND PROTECTION OF CABLES AND OTHER ELEMENTS OF OUTSIDE PLANTS’, INTERNATIONAL TELECOMMUNICATION UNION)
 
[[Category:Terms]]
{{Back to the top}}

Latest revision as of 16:16, 30 July 2024

metalen treksterktegeleider = metallic tensile strength member


Excessive cable tensile loading increases the optical loss and may cause increased residual strain in the fibre if the cable cannot relax. To avoid this, the maximum tensile strength determined by the cable construction, especially the design of the strength member, should not be exceeded.

Note 1 – Where a cable is subjected to permanent loading during its operational life, the fibre should preferably not experience additional strain.

Note 2 – Aerial cable may be attached to a suspension wire. In this case, the strength member of the cable need only be designed to support the load during manufacture and installation.

(‘CONSTRUCTION, INSTALLATION AND PROTECTION OF CABLES AND OTHER ELEMENTS OF OUTSIDE PLANTS’, INTERNATIONAL TELECOMMUNICATION UNION)